Replacement of the ball pin and adjusting screw for the seal kit, injection nozzle 900. 650
Always replace the adjusting screw as well when exchanging the ball pin.
The Elring seal kit, injection nozzle 900.650 contains both components for this purpose. In addition to resulting in far greater wear, the use of an old and worn adjusting screw together with a new ball pin vastly increases the risk of ball pin fracture.
Please avoid fitting an old adjusting screw in combination with a new ball pin.
Related items
-
Ensure that your VAG fuel filters seal correctly
When replacing the fuel filter on certain VAG diesel models it is important upon reassembly that the filter lid is presented squarely to the filter body as it is pressed down to seal the integral... Read more -
Bar's Leak Has Solution for Gradual Oil Buildup in Older Engines
Bar’s Leaks Concentrated Rear Main Seal Repair from Bar’s Products Inc. is designed to quickly and inexpensively solve oil... Read more -
Subaru Seal Tip
When replacing the front crankshaft/oil pump seal on 4-cylinder models of 2008-2011 Subaru Legacy/Outback vehicles, always install a new oil seal, following the installation instructions as specified in the service... Read more -
Jeep is Not Cool
This bulletin applies to 2011 Jeep Wrangler vehicles equipped with a 2.8L engine and air conditioning, built between Jan. 4, 2011, and Jan. 7,... Read more -
Seals that deal with extreme performance from SKF
SKF has developed a highly effective collection of seals for extreme conditions, based on a range of advanced materials. The SKF Spectraseal products are custom-designed for each application and machined from advanced polymeric materials including PTFE, UHMWPE, PEEK, PPS, PA and... Read more
Comments
Login to post comments
social