Displaying items by tag: Mazda - Automotive aftermarket news

Just a Test Noise

This bulletin applies to 2011 Mazda 2 vehicles. Some customers may complain about a slight clunk, bang or jolt from the front of the vehicle after starting the engine and as the vehicle first begins to move forward.

Written by Maksim
Comments (0)
23.11.2016

Rusty Bearing Hum

Some 2009-2013 Mazda6 vehicles may exhibit an unusual humming noise from the front wheel bearings. This may be caused by muddy water entering the wheel bearing(s), causing the bearing(s) to rust. A new bearing seal design has been improved to eliminate this concern.

Written by Maksim
Comments (0)
17.11.2016

Klarius launches 2016 new-to-range parts list

Klarius Products has launched its latest new-to-range parts list, including 48 parts covering 70 product applications for a wide variety of vehicles. The company aims to release new parts into the market on a daily basis as its 2016 priority, Klarius adds. Its current list encompasses numerous vehicle models and sectors, including parts for niche automotive applications as well as mainstream models.

Written by Maksim
Comments (0)
29.01.2016

Vibration in 4WD

Some owners of a 2007-2012 Mazda CX-7 4WD vehicle may notice a vibration from the floor and/or steering wheel during acceleration at approximately 50 mph. To eliminate the concern, the amount of velocity joint grease was increased during production.

Written by Maksim
Comments (0)
26.10.2015

No lift left on switch

This bulletin applies to 2007-2013 Mazda CX9 vehicles. Some vehicles may exhibit inoperation of the power liftgate after battery disconnection and reconnection. Do not replace parts for this concern. The power liftgate will require re-initialization.

Written by Maksim
Comments (0)
21.08.2015

Stop the seepage

Some 2007-2010 Mazda CX-7 and CX-9 4WD vehicles may experience oil seepage from the rear differential oil seal.

Written by Maksim
Comments (0)
15.07.2015

Trouble with Tributes

Some 2010-2011 Mazda Tributes equipped with the 2.5L engine may exhibit DTCs P0016 (crankshaft position – camshaft position correlation – Bank 1 Sensor A), P052A (cold start camshaft position timing over-advanced – Bank 1) and P052B (cold start camshaft position timing over-retarded – Bank 1).