Jeep Pops Out of Gear

Jeep Pops Out of Gear

This bulletin applies to 2007-2010 Jeep Nitro and Wrangler models. The manual transmission may intermittently pop out of gear when accelerating.

Verify that the shift boot is not interfering with the engagement of first gear. If the transmission pops out of gear in first, third and fifth gear, then the shift boot would be the most likely cause for the complaint. If the shift boot is not the cause, it will be necessary to replace the first gear and 1-2 synchronizer assembly.

PARTS NEEDED

P/N                                                               ITEM

68085902AA (NAFTA/Latin America only)…Kit, first gear and 1-2 synchronizer assembly

68080512AB (International only)…………….Kit, first gear  and 1-2 synchronizer assembly

04874464……………………………………....Qty 2, manual trans. Lubricant

04318083……………………………………....Gasket maker

SPECIAL TOOLS

9633……….NSG370 manual transmission build fixture

9636……….Mainshaft/bearing remover

9648……….Mainshaft build fixture

8228……….1-2 synchronizer hub installer

W-262……..Reverse gear synchronizer hub installer

                     Standard 3-jaw gear puller

                     Bearing heater/hot plate

1. Remove the transmission from the vehicle.

2. Disassemble the transmission.

3. Install the new first gear and 1-2 synchronizer assembly onto the mainshaft. Note: When installing the synchronizer sleeve, make sure that the side of the sleeve with the groove faces toward second gear. The selective snap rings are made available in case the mainshaft snap ring is damaged during shaft disassembly. Upon reassembly, select the thickest snap ring that will fit properly in the snap ring groove.

4. Reassemble the transmission using the new front countershaft seal and output shaft seal from the kit.

5. Install the transmission to the vehicle.

6. Fill the transmission with 3.17 pints of Mopar Manual Transmission Lubricant.

Refer to DealerCONNECT > TechCONNECT for detailed service procedures.

Last modified onWednesday, 11 May 2016 08:08
     

   Related items


  • Shift-Popping Hondas
    If a customer with a manual-transmission equipped Honda vehicle (2013 Fit is an example) complains about stiff shifting or popping out of gear, chances are the transmission has old Honda MTF or aftermarket... Read more
  • Jeep is Not Cool
    This bulletin applies to 2011 Jeep Wrangler vehicles equipped with a 2.8L engine and air conditioning, built between Jan. 4, 2011, and Jan. 7,... Read more
  • Mini Shift Issue
    The owner of a 2009 Mini Cooper S may complain about poor shift quality and/or the selector lever quadrant not synchronized with the transmission detents, usually following transmission repairs or engine compartment service. This can be caused by improper handling (bending, mis-adjustment or over-stretching) of... Read more
  • US State Regulator Found Another Cheating Device in Audi Car
    A U.S. regulator found software in some Audi vehicles that lowered their carbon dioxide emissions if it detected they were being used under test conditions, Bild am Sonntag reported... Read more
  • Toyota Grind
    Some 2008-2010 Toyota Sequoia and 2007-2010 Tundra vehicles may exhibit a grinding noise from the front of the vehicle while in 4WD. An updated differential support bolt is available to address this... Read more
Comments
Login to post comments

MOD_LOGINREGISTER_LOGIN_TITLE

Remember Me