Audi: No place for spacer

This bulletin applies to 2007 Audi Cabriolet A4, S4 and RS4 vehicles. A multiple misfire condition may be experienced, with the MIL on and one or more of the following DTCs:
P0300…P0306………Random/multiple cylinder misfire detected
P0335………………..Crankshaft position sensor A (G28) circuit malfunction
P0336………………..Crankshaft position sensor A (G28) circuit range/performance
P0321………………..Ignition/distributor engine speed input circuit range/performance
P0322………………..Ignition/distributor engine speed input circuit – no signal
![]() |
Remove the spacer (No. 3 shown here) located between the engine speed sensor and the gearbox. |
The condition may be caused by a spacer installed between the engine speed sensor and the gearbox.
-
Locate the engine speed sensor.
-
Remove the spacer from between the rpm sensor and the gearbox and discard the spacer.
-
Reinstall the rpm sensor, torquing the bolt to 10 Nm.
-
With VAS 5051 or VAS 5052 diagnostic tool connected, check the ECM for DTCs and for misfire detection in Measuring Value Blocks (MVB) 015 and 016.
-
Erase DTCs as necessary.
social