Shifty Subaru

Shifty Subaru

This TSB involves diagnosing P0851 (neutral switch input circuit low) and P0852 (neutral switch input circuit high) on 2005-2008 Subaru Outback, Impreza and Forester vehicles equipped with the 4EAT.

 

Using the Subaru Select Monitor, check for diagnostic trouble codes stored in memory. If P0851 and/or P0852 are stored in memory, adjust the inhibitor switch and select cable.

  1. Set the select lever to the N range.
  2. Loosen the three inhibitor switch securing bolts.
  3. Insert special tool 499267300 stopper pin as vertical as possible into the holes in the inhibitor switch lever and switch body.
  4. Tighten the three inhibitor switch securing bolts to 2.5 ft.-lbs. and then remove the special tool (pin).
  5. With the select lever already in the N range, loosen the adjusting nuts A and B on both sides.
  6. Turn the adjusting nut B until it lightly touches the connector.
  7. Use a spanner wrench to hold nut B so that it does not rotate, and then tighten the adjusting nut A to 5.5 ft.-lbs.
  8. After the completion of adjustment, confirm that the select lever operates normally at all ranges.

- Move the select lever from P to D. Check that the detents can be felt in each range. If the detents cannot be felt or the position pointer (dash indicator) is improperly aligned, re-adjust the cable.

- Check if the start motor rotates when the select lever is set to the P range.

- Check that the back-up light illuminates when the select lever is in the R range.

- Check the parking lock operation when the select lever is in the P range.

  1. Using the Subaru Select Monitor, clear all DTCs stored in memory. If the codes return after the correct adjustments, refer to the diagnostic procedure found in the applicable Subaru service manual.

 

 

Last modified onFriday, 13 February 2015 13:25
     

   Related items


  • Subaru Seal Tip
    When replacing the front crankshaft/oil pump seal on 4-cylinder models of 2008-2011 Subaru Legacy/Outback vehicles, always install a new oil seal, following the installation instructions as specified in the service... Read more
  • Subaru trans learn
    This TSB applies to a number of Subaru models, including 2004 and later Forester with 4AT and turbo, 2005 and later Forester 4AT naturally aspirated, 2005 and later Impreza 4AT naturally aspirated, 2006 and later Impreza 4AT turbo, 2005 and later Legacy 4AT 2.5L naturally aspirated, 2008 and later Legacy 5AT 3.0L, 2008 and later Legacy 5AT turbo, and 2008 and later Tribeca 5AT 3.6L... Read more
  • Improved air purge
    This TSB applies to 2011-2012 Subaru Legacy/Outback and Tribeca models. If you encounter a vehicle which has P0128 stored in memory, it may be caused by a very slight variation in coolant temperature between the left and right cylinder... Read more
  • MOOG Steering and Suspension line expands
    Federal-Mogul Motorparts announced that the MOOG Steering and Suspension brand has introduced 19 new replacement parts and timesaving alignment tools for more than 14.5 million  passenger... Read more
  • Trans plug change
    This TSB applies to 2008 and later Subaru Legacy and Impreza models equipped with the 6-speed manual... Read more
Comments
Login to post comments

MOD_LOGINREGISTER_LOGIN_TITLE

Remember Me