Audi jumps out of gear

Audi jumps out of gear

Owners of some 2011 Audi A4 and A5 vehicles may complain that the transmission jumps out of 6th gear. A revised/improved range gear recognition switch has been developed to correct this concern.

 

  1.     Check shifter adjustment and verify condition of all shift rods. If the concern is no longer present, no further repairs are needed.
  2.     If the concern remains, remove the transmission.
  3.     Remove the range gear recognition switch F208. This is secured with four Torx drive screws.
  4.    Replace the range gear recognition switch F208, using a new round seal. Be careful not to damage the seal at the lever end. The new recognition switch is available under part number 0B1 301 230 B. The round seal is available as P/N WHT 002 593.
  5.     Reinstall the transmission and verify proper operation.

 

recognition switch

1 – bolts, 2 – gear shift unit


The improved gear shift unit is offered as P/N 0B1 301 230 B.


Last modified onFriday, 06 February 2015 10:33
     

   Related items


  • Audi remote key communication
    This TSB applies to all 2000-2010 Audi models. Potential issue: central locking via the remote control doesn’t work either sporadically or permanently, but the locks can be operated... Read more
  • Shift-Popping Hondas
    If a customer with a manual-transmission equipped Honda vehicle (2013 Fit is an example) complains about stiff shifting or popping out of gear, chances are the transmission has old Honda MTF or aftermarket... Read more
  • Mini Shift Issue
    The owner of a 2009 Mini Cooper S may complain about poor shift quality and/or the selector lever quadrant not synchronized with the transmission detents, usually following transmission repairs or engine compartment service. This can be caused by improper handling (bending, mis-adjustment or over-stretching) of... Read more
  • US State Regulator Found Another Cheating Device in Audi Car
    A U.S. regulator found software in some Audi vehicles that lowered their carbon dioxide emissions if it detected they were being used under test conditions, Bild am Sonntag reported... Read more
  • Shocking the Audi
    This bulletin applies to 2010 Audi Q5 models that feature the adaptive dampers suspension warning light on (Suspension: System Fault), with DTCs 00142, 00143, 00144, 00145 and/or 03264... Read more
Comments
Login to post comments

MOD_LOGINREGISTER_LOGIN_TITLE

Remember Me