Limp Speed Driver Error
This bulletin applies to 2008 Audi Cabriolet A4, S4 and RS4 models. The engine may return to idle speed of approximately 1,400 rpm even with the accelerator depressed. In addition, the engine hesitates and lacks take-off power.
This condition may be caused by driver error, when the brake pedal and accelerator pedal are depressed simultaneously.
With the introduction of “fly-by-wire” Electronic Power Control (EPC) to fuel injection systems, an engine rpm control feature has been incorporated into the engine electronic control system software. Application of both brake and accelerator pedals at the same time after about two seconds results in engine speed to return to 1,400 rpm idle speed.
Yes, some people do drive around with their left foot resting on the brake pedal.
Tags: Audi, Electronic power control, EPC, fuel injection
Related items
-
Audi remote key communication
This TSB applies to all 2000-2010 Audi models. Potential issue: central locking via the remote control doesn’t work either sporadically or permanently, but the locks can be operated... Read more -
US State Regulator Found Another Cheating Device in Audi Car
A U.S. regulator found software in some Audi vehicles that lowered their carbon dioxide emissions if it detected they were being used under test conditions, Bild am Sonntag reported... Read more -
Shocking the Audi
This bulletin applies to 2010 Audi Q5 models that feature the adaptive dampers suspension warning light on (Suspension: System Fault), with DTCs 00142, 00143, 00144, 00145 and/or 03264... Read more -
Audi Hums a Bad Tune
This bulletin applies to the 2012 Audi A5/S5 models. A humming or metallic rattling noise may be heard from under the vehicle, mostly during engine idle or slow... Read more -
Audi offering fast-track certification
Audi is offering apprentice mechanics across Ireland a fast-track option to full Audi... Read more
social