No lift left on switch

No lift left on switch

This bulletin applies to 2007-2013 Mazda CX9 vehicles. Some vehicles may exhibit inoperation of the power liftgate after battery disconnection and reconnection. Do not replace parts for this concern. The power liftgate will require re-initialization.

Before starting initialization, reset Keep Alive Memory (KAM) by disconnecting the negative battery cable and pressing the brake pedal for 15 seconds. Then reconnect the battery cable.

1. Park the vehicle on a level surface. If the liftgate is open, fully close the liftgate manually, then unlock the liftgate and all doors using the transmitter or door lock switch. If the liftgate is closed, unlock the liftgate and all doors using the transmitter or door lock switch, and then open and close the liftgate manually.

2. Press and hold the power liftgate switch or power liftgate button on the transmitter to fully open the liftgate.

3. Press and hold the power liftgate switch or power liftgate button on the transmitter again to fully close the liftgate. The power liftgate is now initialized.

     

   Related items


  • The anatomy of a battery
    Of the myriad of commercial vehicle (CV) components, the humble battery is possibly one of the most difficult to evaluate in terms of its quality, as visually, whether premium or substandard, they all look virtually identical. However, with batteries, the phrase “you get what you pay for” is particularly pertinent, because it’s what’s in the case that makes all the... Read more
  • You have fitted a new battery, but have you told the car?
    There was a time when it was a simple old one out, new one in task. But replacing the battery on a modern vehicle is now much more involved. It is absolutely essential the battery on newer vehicles is replaced with one of the correct specification. If a vehicle is fitted with an AGM Start-Stop battery then the replacement must also be AGM Start-Stop. The same applies to EFB specification... Read more
  • Just a Test Noise
    This bulletin applies to 2011 Mazda 2 vehicles. Some customers may complain about a slight clunk, bang or jolt from the front of the vehicle after starting the engine and as the vehicle first begins to move... Read more
  • Rusty Bearing Hum
    Some 2009-2013 Mazda6 vehicles may exhibit an unusual humming noise from the front wheel bearings. This may be caused by muddy water entering the wheel bearing(s), causing the bearing(s) to rust. A new bearing seal design has been improved to eliminate this... Read more
  • Honda’s new NSX hybrid super car draws on Yuasa power
    Blue Energy, a joint venture between battery manufacturer GS Yuasa and Honda, has announced that their state of the art EHW5 lithium-ion battery will be used on Honda’s new NSX hybrid-powered sports... Read more
Comments
Login to post comments

MOD_LOGINREGISTER_LOGIN_TITLE

Remember Me